Winged Wire Connectors — WLE-P1 to WLE-P2
Winged wire connectors for faster twist-on grip — models WLE-P1 / WLE-P2
Dimensions, wire ranges, and colors are listed exactly as provided
One-hand twist install; no crimping or heat
See the Series Table below; install steps + FAQ at the end
Overview
This page lists winged wire connectors in models WLE-P1 and WLE-P2. Dimensions, suitable wire ranges, and colors below follow your sheet exactly.
Series Table
| Model | Height (mm) | Width (mm) | D (mm) | Suitable Wire | Color |
|---|---|---|---|---|---|
| WLE-P1 | 25 | 18.0 | 9 | 4–6 mm² (AWG12–10) | Yellow |
| WLE-P2 | 29 | 22.0 | 11 | 6–12 mm² (AWG8–6) | Red |
Installation
- Strip conductors as required.
- Align the tips evenly; do not pre-twist.
- Twist the connector clockwise using the wings for grip until firm resistance.
- Perform a pull test on each conductor.
FAQ
Are WLE-P1 and WLE-P2 waterproof?
No. These are winged twist on wire connectors. For sealed splices, use your waterproof (gel-filled) series.
Do they require special tools?
No crimp or heat tools are required. Twist by hand and pull-test after installation.
Can they be used with aluminum conductors?
Use with copper conductors only.
Where can I find packaging or certification info?
Provide those fields and we will add them as dedicated rows without assumptions.
